欢迎访问《农学学报》，
农学学报

农学学报 ›› 2020, Vol. 10 ›› Issue (5): 26-30.doi: 10.11923/j.issn.2095-4050.cjas20191000237

• 农艺科学/生理生化 • 上一篇    下一篇

河套地区种植方式与密度对'张杂谷19号'产量的影响

冯小磊1,2(), 史高雷1,2, 张晓磊1,2, 赵治海1,2, 王晓明1,2()   

  1. (1)张家口市农业科学院，河北张家口 075000
    (2)国家谷子改良中心张家口杂交谷子分中心,河北张家口 075000
  • 收稿日期:2019-10-28 修回日期:2019-12-25 出版日期:2020-05-15 发布日期:2020-05-16
  • 基金资助:
    河北省重点研发计划项目"杂交谷子育种创新及高效制种技术研究"(19226328D)

Effect of Plant Pattern and Density on Yield of Hybrid Millet 'ZZG 19' in Ordos Region

Feng Xiaolei1,2(), Shi Gaolei1,2, Zhang Xiaolei1,2, Zhao Zhihai1,2, Wang Xiaoming1,2()   

  1. (1)Zhangjiakou Academy of Agricultural Sciences, Zhangjiakou 075000, Hebei, China
    (2)National Foxtail Millet Improvement Center, Zhangjiakou Hybrid Millet Sub-Center, Zhangjiakou 075000, Hebei, China
  • Received:2019-10-28 Revised:2019-12-25 Online:2020-05-15 Published:2020-05-16

RichHTML

8

PDF (PC)

419

摘要：

为明确河套地区不同栽培模式对'张杂谷19号'产量的影响,以新抗旱谷子杂交种'张杂谷19号'为试验材料,研究3种种植方式（干旱无膜、干旱覆膜及灌溉无膜）和5种密度（4.5万、9万、13.5万、22.5万、45万株/hm2）对'张杂谷19号'稳产和丰产性的影响。结果表明,正常灌溉条件下,'张杂谷9号'的产量随着种植密度的增加而增加。当密度为45万株/hm2时产量最高,达到8724.36 kg/hm2。而干旱条件下,适宜种植密度可以同样获得较高产量,与正常灌溉条件下最高产量差异不显著。当种植密度为9万~ 45万株/hm2时,产量普遍提高到7700 kg/hm2以上,最高可达8654.33 kg/hm2。河套地区'张杂谷19号'播前灌溉1次足水、地膜覆盖及种植密度9万~45万株/hm2,可以实现水分高效利用和产量达到较高水平。

关键词: 杂交谷子, 种植密度, 抗旱, 河套地区, '张杂谷19号'

Abstract:

To understand the effect of different plant models on the yield of new drought-resistant hybrid millet 'ZZG 19' in Ordos region,3 plant patterns (drought and no plastic film, drought and plastic film, irrigation and no plastic film) and 5 plant densities (45000, 90000, 135000, 225000 and 450000 plants/hm2) were designed to study the stable and high yield ability of the hybrid millet 'ZZG 19'. The results showed that: the yield of 'ZZG 19' was improved with the increase of planting density under normal irrigation condition, and the highest yield was 8724.36 kg/hm2 at 450000 plants/hm2. Under drought condition, higher yield could be obtained by suitable planting density. When the planting density was 90000-450000 plants/hm2, the yield could be above 7700 kg/hm2, with the highest of 8654.33 kg/hm2, which had no significant difference with the highest yield under normal irrigation. Therefore, the suitable water-saving and high-yield planting mode of 'ZZG 19' in Ordos region is: irrigation of full water once before sowing, plastic film mulching and planting density of 90000-450000 plants/hm2, which could obtain high water use efficiency and high yield.

Key words: Hybrid Millet, Plant Density, Drought Stress, Ordos Region, 'ZZG 19'

中图分类号: